Cube Firmware version 5.3.0 is now available

Cube/Brik firmware and documentation

Cube Firmware version 5.3.0 is now available

Postby richard » Wed Mar 21, 2012 12:08 pm

This firmware update adds some new features and improves video quality at lower (<2mbps) bit rates. This will improve the video quality for live streaming, iPad viewing, etc. See the full release notes below.

Download: Teradek_Cube_firmware_v5.3.0r12149.zip

New Features
  • Added Manual Proxy Recording for HDMI encoders
  • Low Bitrate Mode – significantly improves video quality at lower bitrates
  • Enabled 480p and 576p output for HDMI decoders
  • Added support for special characters in wireless passwords

Changes
  • Deinterlacer is enabled by default
  • Redesigned Decoder Settings page
  • Reorganized Encoder Settings page
  • Generic RTMP included by default
  • Analog audio controls enabled on all Cubes with HW version 1.5 or later

Improvements
  • RTMP compatibility/stability improvements
  • Quickview stream uses low bitrate mode, frame rate and resolution adjust for 25/50Hz inputs
  • Decoder restart monitoring
  • Improvements for timestamp sync with 59.94Hz video inputs

Bug Fixes
  • Fixed possible video latency drift present in 5.2.x firmware
  • Fixed missing audio settings on Cube 500 series models
  • Fixed Livestream verification with Bond connected
  • 480i (NTSC) was SDI not detected properly
richard
 
Posts: 68
Joined: Fri Sep 17, 2010 10:12 am
Location: Irvine, CA

Return to Cube/Brik

Who is online

Users browsing this forum: No registered users and 1 guest

Install phpBB web hosting